Display Cluster Current-Topology - 3Com Switch 4500 Family Manual

Table 1-11 Description on the fields of the display cluster black-list command
Device ID
Access Device ID
Access port

display cluster current-topology

Syntax
display cluster current-topology [ mac-address mac-address1 [ to-mac-address mac-address2 ] |
member-id member-id1 [ to-member-id member-id2 ] ]
View
Any view
Parameters
mac-address mac-address1: Displays the topology structure three layers above or below the node
specified by the MAC address. If to-mac-address is specified, mac-address1 is the start point of the
route in the specified route topology displayed.
to-mac-address mac-address2: Displays the topology structure of the route from mac-address1 to
mac-address2.
member-id member-id1: Displays the structure of the standard topology three layers above or below
the node specified by the member ID. If to-member-id is specified, member-id1 is the start point of the
route in the specified route topology displayed.
to-member-id member-id2: Displays the topology structure of the route from member-id1 to
member-id2.
Description
Use the display cluster current-topology command to display the topology of the current cluster.
If to-mac-address or to-member-id is not specified, the system displays the topology structure three
layers below the node specified by the MAC address or member ID.
If to-mac-address or to-member-id is specified, the system displays the topology structure of the route
between the two specified MAC addresses or two member IDs.
When you display the cluster topology information, the devices attached to the switch that is listed in the
backlist will not be displayed.
Field
1-49
Description
ID of the device in the blacklist, expressed by the
MAC address of the device
ID of the device (in the cluster) that is connected
with a device in the blacklist, expressed by the
MAC address of the device
Port (in the cluster) that is connected with a
device in the blacklist