Radius Scheme - 3Com Switch 4500 Family Manual

undo radius nas-ip
View
System view
Parameters
ip-address: Source IP address to be set, an IP address of this device. This address can neither be the
all 0's address nor be a Class-D address.
Description
Use the radius nas-ip command to set the source IP address of outgoing RADIUS messages.
Use the undo radius nas-ip command to restore the default setting.
By default, no source IP address is set, and the IP address of corresponding outbound interface is used
as the source IP address of RADIUS messages.
The nas-ip command in RADIUS scheme view has the same function as the radius nas-ip command
in system view; and the configuration in RADIUS scheme view takes precedence over that in system
view.
Note that:
You can set the source IP address of outgoing RADIUS messages to avoid messages returned
from RADIUS server from being unable to reach their destination due to physical interface trouble.
It is recommended to use a Loopback interface address as the source IP address.
You can set only one source IP address by using this command. When you re-execute this
command again, the newly set source IP address will overwrite the old one.
Related commands: nas-ip.
Examples
# Set source address 129.10.10.1 for outgoing RADIUS messages.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius nas-ip 129.10.10.1

radius scheme

Syntax
radius scheme radius-scheme-name
undo radius scheme radius-scheme-name
1-43