Build - 3Com Switch 4500 Family Manual

build

Syntax
build name
undo build
View
Cluster view
Parameters
name: Name to be set for the cluster, a string of up to 8 characters, which can only be alphanumeric
characters, minus signs (-), and underscores (_).
Description
Use the build command to build a cluster with a cluster name or change the cluster name.
Use the undo build command to remove the cluster.
You can use this command on a candidate device as well as on a management device.
Executing the build command on a candidate device will change the device to a management device
and assign a name to the cluster created on the device, and the member number of the management
device is 0.
Executing the build command on a management device will change the cluster name.
Different from the auto-build command, the build command only builds a cluster on the management
device, which will not immediately collect the topology information to add the candidate devices into the
cluster, but wait for an interval (configured through the ntdp timer command) before it starts the
topology collection.
1-17