Copy Configuration - 3Com Switch 4500 Family Manual

The global broadcast suppression setting configured by the broadcast-suppression command in
system view takes effect on all Ethernet ports in the system except for the reflection ports, stack ports
and ports having their own broadcast suppression settings.
If you configure broadcast-suppression command in both system view and Ethernet port view, the
configuration in Ethernet port view will take effect.
Examples
# Allow incoming broadcast traffic on Ethernet 1/0/1 to occupy at most 20% of the total transmission
capacity of the port and suppress the broadcast traffic that exceeds the specified range.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] broadcast-suppression 20
# Set the maximum number of broadcast packets that can be received per second by the Ethernet 1/0/1
port to 1,000.
[Sysname-Ethernet1/0/1] broadcast-suppression pps 1000

copy configuration

Syntax
copy configuration source { interface-type interface-number | aggregation-group source-agg-id }
destination { interface-list [ aggregation-group destination-agg-id ] | aggregation-group
destination-agg-id }
View
System view
Parameters
interface-type: Port type.
interface-number: Port number.
source-agg-id: Source aggregation group number, in the range of 1 to 416. The port with the smallest
port number in the aggregation group is used as the source port.
destination-agg-id: Destination aggregation group number, in the range of 1 to 416.
interface-list: Destination port list, interface-list = interface-type interface-number [ to interface-type
interface-number ] &<1-10. &<1-10> means that you can input up to 10 ports/port ranges.
Description
Use the copy configuration command to duplicate the configuration of a port to specified ports to keep
consistent configuration on them.
1-2