1
QoS Commands
QoS Commands
display protocol-priority
Syntax
display protocol-priority
View
Any view
Parameters
None
Description
Use the display protocol-priority command to display the list of protocol priorities you assigned with
the protocol-priority command.
A Switch 4500 supports setting priorities for certain protocol packets generated by it. The supported
protocols are Telnet, SNMP, ICMP, and OSPF. Depending on your configuration, the IP or DSCP
precedence is displayed for a specified protocol.
Related commands: protocol-priority.
Examples
# Display the list of protocol priorities manually specified.
<Sysname> display protocol-priority
Protocol: ospf
IP-Precedence: routine(0)
Protocol: telnet
DSCP: be(0)
Table 1-1 Description on the fields of the display protocol-priority command
Field
Protocol: ospf
IP-Precedence: routine(0)
Indicate that a priority has been set for OSPF packets with the
protocol-priority command.
An IP precedence has been assigned to OSPF packets. The assigned
IP precedence is 0, that is, routine in words.
For information about the IP precedence range, refer to
1-1
Description
Table
1-6.