Priority
Fabric-Port
A/M
display xrn-fabric
Syntax
display xrn-fabric [ port ]
View
Any view
Parameters
port: Displays the fabric port information.
Description
Use the display xrn-fabric command to view the information of the entire fabric, including unit ID, unit
name, and operation mode of the system. If the fabric information is displayed on the console port of a
device, an asterisk (*) will be added to the unit ID of the current device.
Examples
# Display fabric information on the console port of unit 1.
<Sysname> display xrn-fabric
Fabric name is Sysname, system mode is L3.
Unit Name
First
Second
From the above example, you can see the following:
The name of the fabric is Sysname.
The system operation mode is Layer 3 forwarding.
The current device is 1 (marked by *)
The name of the current device is First (the name of a device can be configured by using the set
unit name command)
The other unit in the fabric is numbered 2
Field
Priority value:
10 means the switch adopts automatic
numbering
5
means
the
numbering
Manual numbering has a higher priority than
automatic numbering.
Fabric port, In a bus topology structure, the units
at both ends of the bus have only one fabric port
connected, displayed as Left/ or /Right.
Indicates that the switch adopts automatic
numbering or manual numbering:
A for automatic
M for manual
Unit ID
1(*)
2
1-7
Description
switch
adopts
manual