3Com Switch 4500 Family Manual page 114

If you specify a source aggregation group ID, the system uses the port with the smallest port
number in the aggregation group as the source.
If you specify a destination aggregation group ID, the configuration of the source port will be copied
to all ports in the aggregation group and all ports in the group will have the same configuration as
that of the source port.
Refer to Table 1-1
Table 1-1 Configurations that can be copied
Configuration category
VLAN
LACP (Link Aggregation
Control protocol)
QoS
STP
Basic port configuration
In case a configuration setting fails to be copied, the system will print the error message.
Examples
# Copy the configurations of Ethernet 1/0/1 to Ethernet 1/0/2 and Ethernet 1/0/3.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] copy configuration source ethernet 1/0/1 destination ethernet 1/0/2 ethernet 1/0/3
Note: The following port(s) will be removed from destination port list:
Aggregation port(s),Voice vlan port(s).
Copying VLAN configuration...
Copying LACP configuration...
Copying QOS configuration...
Copying STP configuration...
Copying speed/duplex configuration...
for the configurations that can be copied.
VLANs carried on the port and the default VLAN ID.
The enable/disable status of LACP.
(As the configuration commands of manual and static link
aggregation groups cannot be copied, you cannot assign a port to a
link aggregation group with the copy command.)
packet priority marking, port priority, VLAN mapping, port rate
limiting, priority trust mode, and so on.
The enable/disable state of STP on the port, link attribute of the port
(point-to-point or non-point-to-point), STP priority, path cost,
transmission rate limit, enable/disable state of loop protection,
enable/disable state of root protection, and whether the port is an
edge port.
Link type of the port, port rate, and duplex mode.
Contents
1-3