Display Unit - 3Com Switch 4500 Family Manual

<Sysname> display port combo
Combo-group
1
2
Table 1-6 display port combo command output description
Field
Combo-group
Active
Inactive
As for the optical port and the electrical port of a Combo port, the one with the smaller port number is
active by default. You can determine whether a port is an optical port or an electrical port by checking
the "Media type is" field of the display interface command.

display unit

Syntax
display unit unit-id interface
View
Any view
Parameters
unit-id: Unit ID.
Description
Use the display unit command to display information about the ports on a specified unit.
Examples
# Display information about the ports on unit 1.
<Sysname> display unit 1 interface
Aux1/0/0
Description :
Ethernet1/0/1 current state : DOWN
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 000f-e290-2240
Media type is twisted pair, loopback not set
Port hardware type is 100_BASE_TX
100Mbps-speed mode, full-duplex mode
Link speed type is force link, link duplex type is force link
Flow-control is enabled
The Maximum Frame Length is 9216
Broadcast MAX-pps: 500
Unicast MAX-ratio: 100%
Active
GigabitEthernet1/0/25
GigabitEthernet1/0/26
Combo ports of the device, represented by Combo port number, which
is generated by the system.
Ports of the Combo ports that are active
Ports of the Combo ports that are inactive
Aux Interface
Inactive
GigabitEthernet1/0/27
GigabitEthernet1/0/28
Description
1-12