Server-Type - 3Com Switch 4500 Family Manual

Use the undo secondary authentication command to restore the default IP address and port number
of the secondary RADIUS authentication/authorization server, which is 0.0.0.0 and 1812 respectively.
Related commands: key, radius scheme, state.
Examples
# Set the IP address and UDP port number of the secondary authentication/authorization server for
RADIUS scheme radius1 to 10.110.1.2 and 1812 respectively.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
[Sysname-radius-radius1] secondary authentication 10.110.1.2 1812

server-type

Syntax
server-type { extended | standard }
undo server-type
View
RADIUS scheme view
Parameters
extended: Specifies to support H3C's RADIUS server (which is generally a CAMS), that is, use the
procedure and message format of private RADIUS protocol to interact with an H3C's RADIUS server.
standard: Specifies to support standard RADIUS server, that is, use the procedure and message
format of a standard RADIUS protocol (RFC 2865/2866 or above) to interact with a standard RADIUS
server.
Description
Use the server-type command to configure the switch to support a specified type of RADIUS server.
Use the undo server-type command to restore the default setting.
By default, the switch supports RADIUS servers of the standard type, and the RADIUS server type in
the default scheme named system is extended.
Related commands: radius scheme.
Examples
# Configure the switch to support H3C's RADIUS server in RADIUS scheme radius1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] radius scheme radius1
New Radius scheme
1-51