3Com Switch 4500 Family Manual page 909

undo am trap enable
View
System view
Parameters
None
Description
Use the am trap enable command to enable the access management trap function.
Use the undo am trap enable command to disable the access management trap function.
By default, the access management trap function is disabled.
Examples
# Enable the access management trap.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] am trap enable
display am
Syntax
display am [ interface-list ]
View
Any view
Parameters
interface-list: Port list. You need to provide this argument in the format of { interface-type
interface-number [ to interface-type interface-number ] } &<1-10>, where interface-type is
port type, interface-number is port number, and &<1-10> means that you can specify up to
ten ports/port lists.
Description
Use the display am command to display the current access management configuration,
including the status (enabled/disabled), and the access management IP address pool
configuration information.
If you do not specify the interface-list argument, this command displays the current access
management configuration of all the ports.
Examples
# Display the access management configurations of Ethernet 1/0/1 and Ethernet 1/0/2.
<Sysname> display am Ethernet 1/0/1 Ethernet 1/0/2
Ethernet1/0/1
Status
IP Pools
: enabled
: 10.10.1.1(19) 10.10.1.30(1)
1-3