3Com Switch 4500 Family Manual page 500

View
Any view
Parameters
interface-type interface-number: Specifies the type and number of a port, for which QoS configuration
information is to be displayed.
unit-id: Unit ID of the switch whose QoS-related configuration is to be displayed.
value range for the unit-id argument.
Table 1-2 The value range for the unit-id argument
For a switch not in a fabric
Always 1
Description
Use the display qos-interface all command to display all the QoS-related configuration settings of a
port or a unit.
Examples
# Display all the QoS-related configuration of Ethernet 1/0/1.
<Sysname> display qos-interface Ethernet 1/0/1 all
Ethernet1/0/1: traffic-limit
Inbound:
Matches: Acl 2000 rule 0
Effect mode: Union effect
Egress port: Ethernet1/0/2
Target rate: 64 Kbps
Burst bucket size: 16 Kbyte
Exceed action: remark-dscp cs7
Ethernet1/0/1: traffic-priority
Inbound:
Matches: Acl 2000 rule 0
Priority action: dscp cs6
Ethernet1/0/1: mirrored-to
Inbound:
Matches: Acl 2000 rule 0
The unit ID ranges from 1 to 8, depending on the unit ID of
the switch in the fabric. For example, if two switches form a
fabric, with the unit IDs being 3 and 5 respectively, the unit
IDs of the two switches can only be 3 and 5.
running
running
running
1-3
For a switch in a fabric
Table 1-2 shows the