3Com Switch 4500 Family Manual page 555

Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0
Interface: Ethernet1/0/3
Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0
......(Omitted)
# Display NDP information about Ethernet 1/0/1.
<aaa_0.Sysname> display ndp interface Ethernet 1/0/1
Interface: Ethernet1/0/1
Status: Enabled, Pkts Snd: 15835, Pkts Rvd: 2879, Pkts Err: 0
Neighbor 1: Aging Time: 147(s)
MAC Address : 000f-e20f-1234
Port Name : Ethernet1/0/1
Software Ver: 3Com OS V3.03.00s56c01
Device Name : Switch 4500 26-Port
Port Duplex : AUTO
Product Ver : Switch 4500 26-Port
Table 1-1 Description on the fields of the two commands
Field
Neighbor Discovery Protocol is enabled
Neighbor Discovery Protocol Ver: 1
Hello Timer
Aging Timer
Interface
Status
Pkts Snd:
Pkts Rvd:
Pkts Err:
Neighbor 1: Aging Time
MAC Address
Port name
Software Ver
Device Name
Port Duplex
Product Ver
NDP is enabled globally on the switch.
NDP version 1 is running.
Interval for the switch to send NDP packets,
which is configured through the ndp timer hello
command
Holdtime for neighbors to keep the NDP
information of the switch, which is configured
through the ndp timer aging command
Port index, used to identify a port
NDP state on the port (enabled/disabled)
Number of NDP packets sent by the port
Number of NDP packets received by the port
Number of error NDP packets received by the
port
Holdtime for this switch to keep the NDP
information of the neighbor connected to the port
MAC address of the neighbor device
Port name of the neighbor device
Software version of the neighbor device
Device name of the neighbor device
Port (full/half) duplex mode of the neighbor
device
Product version of the neighbor device
1-2
Description