3Com Switch 4500 Family Manual page 610

Examples
# Display the PoE status of Ethernet 1/0/10.
<Sysname> display poe interface Ethernet1/0/10
Port power enabled
Port power ON/OFF
Port power status
Port power mode
Port PD class
port power priority
Port max power
Port current power
Port peak power
Port average power
Port current
Port voltage
Table 1-1 display poe interface command output description
Port power enabled
Port power ON/OFF
Port power status
Port power mode
Port PD class
Port power priority
Port max power
Port current power
Port average power
Port peak power
Port current
Port voltage
# Display the PoE status of all ports.
<Sysname> display poe interface
PORT INDEX
:enable
:on
:Standard PD was detected
:signal
:0
:low
:15400 mW
:460 mW
:552 mW
:547 mW
:10 mA
:51 V
Field
POWER ENABLE MODE
PoE is enabled on the port
The power on the port is on/off
PoE status on the port:
user command set port to off: PoE to the port
is turned off by the user
Standard PD was detected: A standard PD is
detected
detection is in process: PDs are being
detected
PoE mode on the port:
signal: PoE through the signal cable
Class of power to the PD
PoE priority of the port:
critical: The highest
high: High
low: Low
The maximum available power on the port
The current power on the port
The average power on the port
The peak power on the port
The current on the port
The voltage on the port
PRIORITY STATUS
1-2
Description