Mirroring-Group Remote-Probe Vlan - 3Com Switch 4500 Family Manual

Parameters
group-id: Number of a port mirroring group, in the range 1 to 20.
reflector-port reflector-port: Specifies the reflector port. reflector-port is available in
system view only, and there is no such argument in Ethernet port view.
Description
Use the mirroring-group reflector-port command to specify the reflector port for a
remote source mirroring group.
Use the undo mirroring-group reflector-port command to remove the reflector port of a
remote source mirroring group.
Note the following when you configure the reflector port:
The reflector port cannot be a member port of an existing mirroring group, a fabric port,
a member port of an aggregation group, or a port enabled with LACP or STP. It must be
an access port and cannot be configured with functions like VLAN-VPN, port loopback
detection, packet filtering, QoS, port security, and so on.
When a port is configured as a reflector port, the switch configures its link state as up,
duplex mode as full, and port rate as the maximum rate supported on the port. You
cannot modify the duplex mode, port rate, and MDI attribute of a reflector port.
It is recommended that you use a reflector port for port mirroring purpose only.
Examples
# Configure Ethernet 1/0/2 as the reflector port of remote source mirroring group 1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 reflector-port Ethernet 1/0/2

mirroring-group remote-probe vlan

Syntax
mirroring-group group-id remote-probe vlan remote-probe-vlan-id
undo mirroring-group group-id remote-probe vlan remote-probe-vlan-id
View
System view
Parameters
group-id: Number of a port mirroring group, in the range 1 to 20.
remote-probe vlan remote-probe-vlan-id: Specifies the remote-probe VLAN for the
mirroring group.
1-6