Usb/Nic Function Enable - Ricoh B264 Service Manual

INSTALLING CONTROLLER OPTIONS
21. If there was no HDD in the machine before you installed the printer/scanner kit,
do SP5846 41 to let the user get access to the address book.
Important
•
This SP must be done immediately after installation of an HDD unit in a
machine that previously had no HDD.
•
The first time the machine power is turned on with the new HDD installed,
the system automatically takes the address book from the NVRAM and
writes it on the new HDD. But, only the system administrator can get
access to the new address book on the HDD at this time.
•
If you do SP5846 41 immediately after power on, then all users can use the
address book.
NOTE: It is not necessary to format the HDD.

1.4.2 USB/NIC FUNCTION ENABLE

The NIB and USB functions are built into the controller. Installation procedures for
these functions are not necessary. However, these functions must be enabled with
SP5985.
1. If you want to use the Ethernet function, enter the SP mode and set SP5985-
001 (On Board NIC) to "1" (Enable).
2. If you want to use the USB function, enter the SP mode and set SP5985-002
(On Board USB) to "1" (Enable).
B783 10 SM