Ricoh B264 Service Manual page 318

SERVICE PROGRAM MODE TABLES
5836 94 Default Format for Backup
Files
5836 95 Default Resolution for
Backup Files
5836 97 Default Compression for
Backup Files
5836 98 Back Projection Removal
5839 IEEE 1394
This SP is displayed only when an IEEE 1394 (firewire) card is installed.
5839 4 Host Name
Enter the name of the device used on the network. Example: RNP0000000000
5839 7 Cycle Master
Enables or disables the cycle master function for the 1394 bus standard.
[0~1/1]
0: Disable (Off)
1: Enable (On)
5839 8 BCR Mode
Determines how BCR (Broadcast Channel Register) operates on the 1394 standard
bus when the independent node is in any mode other than IRM. (NVRAM: 2-bits)
[Always Effective]
5839 9 IRM 1394a Check
Conducts a 1394a check of IRM when the independent node is in any mode other
than IRM.
[0~1/1]
0: Checks whether IRM conforms to 1394a
1: After IRM is checked, if IRM does not conform then independent node switches to
IRM.
5839 10 Unique ID
Lists the ID (Node_Unique_ID) assigned to the device by the system administrator.
Bit0: Off
Bit1: On
OFF: Does not list the Node_Unique_ID assigned by the system administrator.
Instead, the Source_ID of the GASP header in the ARP is used.
ON: The Node_Unique_ID assigned by the system administrator is used, and the
Source_ID of the GASP header in the ARP is ignored. Also, when the serial
bus is reset, extra bus transactions are opened for the enumeration.
B264/B265
Sets the format of the backup files.
[0~2/1]
0: TIFF
1: JPEG
2: For printing
This feature can be selected only if SP5836-3 is set to
"1".
Sets the resolution conversion ratio for the backup files.
[0~3/1]
0: 1x
1: 1/2x
2: 1/3 x
3: 1/4x
Sets the rate of compression for the backup files.
[0~2/1]
0: Standard
1: Low
2: High
Removes the ghost images that are copied from the
back sides of two-sided originals.
[0~1/1]
0: Disable
1: Enable
5-54 SM