Reinstalling - Ricoh B264 Service Manual

Reinstalling

[B]
[B]
[A, B]
1. Line up the two small holes [A] in the folder plate with the two small protrusions
on the bottom of the securing plate [B]. Then, push the two protrusions through
the holes.
Note: Be sure that the three screw holes are also lined up.
2. Temporarily fix the two plates together by attaching two strips of electrical tape
[C] along the line where they meet (see the illustration).
NOTE: 1) Be sure to fold the two strips back toward you so that they can
easily be removed.
2) Be careful not to attach the tape too close to the three screw holes.
3. Reattach the two plates [A, B] to the folder table [D] ( x 3).
NOTE: Tighten these three screws while holding the securing plate against the
two positioning screws [E] that were installed in step 3 of the "Removal"
procedure.
4. Remove the two strips of tape.
SM
[A]
[A]
B546R575.PCX
B546R577.PCX
33
[C]
[D]
REMOVAL
B546R578.PCX
[E]
B546R576.PCX
B546