Ricoh B264 Service Manual page 796

BIT SWITCHES
System Switch 12
No FUNCTION
0 TTI printing position in the main
to scan direction
7
System Switch 13 - Not used (do not change these settings)
System Switch 14 - Not used (do not change these settings)
System Switch 15
No FUNCTION
0 Not used
1 Going into the Energy Saver
mode automatically
0: Enabled
1: Disabled
2-3 Not used
4-5 Interval for preventing the
machine from entering Energy
Saver mode if there is a
pending transmission file.
Bit 5 4
0 0
0 1
1 0
1 1
6-7 Not used
B779
Setting
1 min
30 min
1 hour
24 hours
COMMENTS
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position for
the TTI from the left edge of the paper. If the TTI is
moved too far to the right, it may overwrite the file
number which is on the top right of the page. On an
A4 page, if the TTI is moved over by more than 50
mm, it may overwrite the page number.
COMMENTS
Do not change the settings.
1: The machine will restart from the Energy Saver
mode quickly, because the +5V power supply is
active even in the Energy Saver mode.
Do not change these settings.
If there is a file waiting for transmission, the machine
does not go to Energy Saver mode during the
selected period.
After transmitting the file, if there is no file waiting for
transmission, the machine goes to the Energy Saver
mode.
Do not change
44
SP No. 1-101-019
SP No. 1-101-022
SM