Ricoh B264 Service Manual page 251

860 B HDD startup error at main power on
• HDD is connected but a driver
error is detected.
• The driver does not respond with
the status of the HDD within 30
s.
863 D HDD data read failure
The data written to the HDD cannot
be read normally, due to bad
sectors generated during operation.
864 D HDD data CRC error
During HDD operation, the HDD
cannot respond to an CRC error
query. Data transfer did not execute
normally while data was being
written to the HDD.
865 D HDD access error
HDD responded to an error during
operation for a condition other than
those for SC863, 864.
866 B SD card error 1: Confirmation
The machine detects an electronic license error in the application on the SD card
in the controller slot immediately after the machine is turned on. The program on
the SD card contains electronic confirmation license data. If the program does not
contain this license data, or if the result of the check shows that the license data in
the program on the SD card is incorrect, then the checked program cannot
execute and this SC code is displayed.
• Program missing from the SD card
• Download the correct program for the machine to the SD card
867 D SD card error 2: SD card removed
The SD card in the boot slot when
the machine was turned on was
removed while the machine was on.
868 D SD card error 3: SC card access
SM
SERVICE CALL CONDITIONS
• HDD is not initialized
• Level data is corrupted
• HDD is defective
• HDD defective
Note: If the bad sectors are generated at
the image partition, the bad sector
information is written to NVRAM, and the
next time the HDD is accessed, these bad
sectors will not be accessed for read/write
operation.
• HDD defective
• HDD defective.
• Insert the SD card, then turn the machine
off and on.
4-23 B264/B265