Ricoh B264 Service Manual page 772

ERROR CODES
Code Meaning
15-81 Repeated Destination
Registration Error
15-91 Send Registration Error
15-92 Memory Overflow
15-93 Memory Access Error
15-94 Incorrect ID Code
15-95 Transfer Station Function
22-00 Original length exceeded the
maximum scan length
22-01 Memory overflow while
receiving
22-02 Tx or rx job stalled due to
line disconnection at the
other end
22-04 The machine cannot store
received data in the SAF
22-05
No G3 parameter
confirmation answer
23-00 Data read timeout during
construction
25-00 The machine software
resets itself after a fatal
transmission error occurred
F0-xx V.34 modem error
F6-xx SG3-V34 modem error
B779
Suggested Cause/Action
Could not repeat receive the transmission because
the destination buffer is full and the destination
could not be created (this error may occur when
receiving a transfer request or a request for
notification of reception).
Could not receive the file for transfer to the final
destination:
• The format of the final destination or the transfer
destination is incorrect.
•
Destinations are full so the final and transfer
destinations could not be created.
Transmission could not be received because
memory overflowed during the transaction.
Transaction could not complete due to a malfunction
of SAF memory.
The machine rejected an incoming e-mail for
transfer request, because the ID code in the
incoming e-mail did not match the ID code
registered in the machine.
The machine rejected an incoming e-mail for
transfer because the transfer function was
unavailable.
Divide the original into more than one page.
Check the resolution used for scanning. Lower the
scan resolution if possible.
Add optional page memory.
Wait for the files in the queue to be sent.
Delete unnecessary files from memory.
Transfer the substitute reception files to an another
fax machine, if the machine's printer is busy or out
of order.
Add an optional SAF memory card or hard disk.
The job started normally but did not finish normally;
data may or may not have been received fully.
Restart the machine.
• Update the ROM
• Replace the FCU.
• Defective FCU board or firmware.
Restart the machine.
Replace the FCU
• Update the ROM
• Replace the FCU.
Replace the FCU.
Update the SG3-V34 modem ROM.
Replace the SG3-V34 board.
• Check for line noise or other line problems.
• Try communicating another V.8/V.34 fax.
20 SM