Undo Exec - Ricoh B264 Service Manual

MERGING APPLICATIONS ON ONE SD CARD
Important!
• After an SD card is copied, it cannot be used. But it must be stored in the
front door, to serve as proof of purchase by the customer.
• The original card can also be used to perform an undo procedure (SP 5873
002). Before you put the card in the front cover, label it carefully so that you
can identify it easily if you need to do the undo procedure (see the next
page).

1.3.3 UNDO EXEC

1. Turn the main switch off.
2. Put the SD card with the merged applications in C1.
3. Put the original destination SD card (the one taped to the faceplate of the
controller box) into C3.
NOTE: The SD card in C3 must be the original SD card of the application you
want to move from C1 to C3. You cannot use any blank SD card in C3.
4. Turn the main switch on.
5. Go into the SP mode and do SP5873-002 (Undo Exec)
6. Follow the messages on the operation panel to complete the procedure.
7. Turn the main switch off.
8. Remove the SD cards from the slots.
9. Turn the main switch on.
B783 6 SM