Ricoh B264 Service Manual page 810

BIT SWITCHES
Printer Switch 0E
No FUNCTION
0 Paper size selection priority
0: Width
1: Length
1 Paper size selected for
printing A4 width fax data
0: 8.5" x 11" size
1: A4 size
2 Page separation
0: Enabled
1: Disabled
3 Printing the sample image on
to reports
4 Bit 4 Bit 3
0 0
0 1
1 0
1 1
5-6 Not used
7 Equalizing the reduction ratio
among separated pages
(Page Separation)
0: Enabled
1: Disabled
Printer Switch 0F
No FUNCTION
0 Smoothing feature
to Bit 1 Bit 0
1 0 0
0 1
1 0
1 1
2 Duplex printing
0: Disabled
1: Enabled
3 Binding direction for Duplex
printing
0: Left binding
1: Top binding
4-7 Not used
B779
0: A paper size that has the same width as the
received data is selected first.
1: A paper size which has enough length to print all
the received lines without reduction is selected first.
This switch determines which paper size is selected
for printing A4 width fax data, when the machine has
both A4 and 8.5" x 11" size paper.
1: If all paper sizes in the machine require page
separation to print a received fax message, the
machine does not print the message (Substitute
Reception is used).
After a larger size of paper is set in a cassette, the
machine automatically prints the fax message.
"Same size" means the sample image is printed at
100%, even if page separation occurs.
Setting
User Parameter Switch 19 (13H) bit 4 must be set to
The upper half
"0" to enable this switch.
only
Refer to Detailed Section Descriptions for more on
50% reduction
this feature.
in sub-scan only
Same size
Not used
Do not change the settings.
0: When page separation has taken place, all the
pages are reduced with the same reduction ratio.
1: Only the last page is reduced to fit the selected
paper size when page separation has taken place.
Other pages are printed without reduction.
Setting
Disabled
Disabled
Enabled
Not used
COMMENTS
COMMENTS
(0, 0) (0, 1): Disable smoothing if the machine
receives halftone images from other manufacturers
fax machines frequently.
1: The machine always prints received fax
messages in duplex printing mode:
0: Sets the binding for the left edge of the stack.
1: Sets the binding for the top of the stack.
Do not change the settings.
58
SP No. 1-103-015
SP No. 1-103-016
SM