5828
Network Setting
582850
1284 Compatibility
(Centro)
582852
ECP (Centro)
582865
Job Spool Setting
582866
Job Spool Clear
582869
Job Spool Protocol
582877
IPv4 DNS Server 2
582878
IPv4 DNS Server 3
582879
Domain Name
(Ethernet)
582884
Setting List PrintPrint
Settings List
582890
TELNET Operation
SettingsTELNET (0:OFF
1:ON)
582891
Web Operation Web
(0:OFF 1:ON)
582896
Rendezvous Operation
SM
SERVICE PROGRAM MODE TABLES
Enables and disables bi-directional communication on the
parallel connection between the machine and a computer.
[0~1/1]
0:Off
1: On
Disables and enables the ECP feature (1284 Mode) for
data transfer.
[0~1/1]
0: Disabled
1: Enabled
Switches job spooling spooling on and off.
0: No spooling 1: Spooling enabled
This SP determines whether the job interrupted at power
off is resumed at the next power on. This SP operates
only when SP5828065 is set to 1.
1: Resumes printing spooled jog.
0: Clears spooled job.
This SP determines whether job spooling is enabled or
dispabled for each protocol. This is a 8-bit setting.
0
LPR
1
FTP (Not Used)
2
IPP
3
SMB
Sets the IPv4 address for a DNS server. This address can
be used among devices that have IPv4 devices (Ethernet,
IPv4 Over 1394, IEEE 802.11b, etc.)
Prints a list of the NCS parameter settings.
Disables or enables Telnet operation. If this SP is
disabled, the Telnet port is closed.
[0~1/1]
0: Disable
1: Enable
Disables or enables the Web operation.
[0~1/1]
0: Disable
1: Enable
This SP disables/enables Rendezvous operation.
This is a set of protocols that allows a device on an IP
network to automatically recognize and connect with other
devices (such as a printer) on a network. Once a new
device is connected to the network, it can be used
immediately by every computer on the network. No
special setup procedures or configuration settings are
required
1: Enable 0: Disable
5-51
4
BMLinks (Japan Only)
5
DIPRINT
6
Reserved (Not Used)
7
Reserved (Not Used)
B264/B265