Ricoh B264 Service Manual page 791

System Switch 00
No FUNCTION
4 Line error mark print
0: OFF, 1: ON (print)
5 G3/G4 communication
parameter display
0: Disabled
1: Enabled
6 Protocol dump list output after
each communication
0: Off
1: On
7 Not used
G3 Communication Parameters
Modem rate 336: 33600 bps
312: 31200 bps
288: 28800 bps
264: 26400 bps
240: 24000 bps
216: 21600 bps
192: 19200 bps
Resolution S: Standard (8 x 3.85 dots/mm)
D: Detail (8 x 7.7 dots/mm)
F: Fine (8 x 15.4 dots/mm)
SF: Superfine (16 x 15.4 dots/mm)
21: Standard (200 x 100 dpi)
22: Detail (200 x 200 dpi)
44: Superfine (400 x 400 dpi)
Compression mode MMR: MMR compression
MR: MR compression
MH: MH compression
JBO: JBIG compression (Optional mode)
JBB: JBIG compression (Basic mode)
Communication ECM: With ECM
mode NML: With no ECM
Width and A4: A4 (8.3"), no reduction
reduction B4: B4 (10.1"), no reduction
A3: A3 (11.7"), no reduction
I/O rate 0: 0 ms/line
25: 2.5 ms/line
5: 5 ms/line
Note:
"40" is displayed while receiving a fax message using AI short
protocol.
System Switch 01 - Not used (Do not change the factory settings.)
SM
COMMENTS
When "1" is selected, a line error mark is printed on
the printout if a line error occurs during reception.
This is a fault-finding aid. The LCD shows the key
parameters (see below). This is normally disabled
because it cancels the CSI display for the user.
Be sure to reset this bit to 0 after testing.
This is only used for communication
troubleshooting. It shows the content of the
transmitted facsimile protocol signals. Always reset
this bit to 0 after finishing testing.
If system switch 09 bit 6 is at "1", the list is only
printed if there was an error during the
communication.
Do not change the setting.
168: 16800 bps
144: 14400 bps
120: 12000 bps
96: 9600 bps
72: 7200 bps
48: 4800 bps
24: 2400 bps
10: 10 ms/line
20: 20 ms/line
40: 40 ms/line
39
BIT SWITCHES
SP No. 1-101-001
B779