Printer Switches - Ricoh B264 Service Manual

BIT SWITCHES

3.2.3 Printer Switches

Printer Switch 00
No FUNCTION
0
Select page separation marks
0: Off
1: On
1 Repetition of data when the
received page is longer than
the printer paper
0: Off
1: On
2 Prints the date and time on
received fax messages
0: Disabled
1: Enabled
3-7 Not used
Printer Switch 01
No FUNCTION
0-2 Not used
3-4 Maximum print width used in
the setup protocol
Bit 4 3
0 0
0 1
1 0
1 1
5-6 Not used
7 Received message width
restriction in the protocol signal
to the sender
0: Disabled
1: Enabled
B779
Setting
Not used
A3
B4
A4
COMMENTS
0: If a 2 page RX transmission is split, [*] is printed
in the bottom right corner of the 1st page and only a
[2] is printed in the upper right corner of the 2nd
page.
1: If a 2 page RX transmission is split into two
pages, for example, [*] [2] is printed in the bottom
right corner of the 1st page and only a [2] is printed
in the upper right corner of the 2nd page.
Note: This helps the user to identify pages that have
been split because the size of the paper is smaller
than the size of the document received. (When A5 is
used to print an A4 size document, for example.)
1: Default. 10 mm of the trailing edge of the
previous page are repeated at the top of the next
page.
0: The next page continues from where the previous
page stopped without any repeated text.
This switch is only effective when user parameter 02
- bit 2 (printing the received date and time on
received fax messages) is enabled.
1: The machine prints the received and printed date
and time at the bottom of each received page.
Do not change the settings.
COMMENTS
Do not change the settings.
These bits are only effective when bit 7 of printer
switch 01 is "1".
Do not change the settings.
0: The machine informs the transmitting machine of
the print width depending on the paper size
available from the paper feed stations.
Refer to the table on the next page for how the
machine chooses the paper width used in the setup
protocol (NSF/DIS).
1: The machine informs the transmitting machine of
the fixed paper width which is specified by bits 3 and
4 above.
54
SP No. 1-103-001
SP No. 1-103-002
SM