Configuring Mpls; Enabling Mpls; Configuring Ldp Router-Id - Zte ZXR10 8900 Series User Manual

ZXR10 8900 Series User Manual (MPLS Volume)
St- Command
ep
1
ZXR10(config)#
2
ZXR10(config)#
3
ZXR10(config-if)#
18 Confidential and Proprietary Information of ZTE CORPORATION
and R2 choose a master according to IP addresses. The router
with bigger IP address will acts as the master. The master
initiates TCP connection. Here suppose that IP address of R2
is bigger. Therefore, R2 sends TCP connection request.
3. R2 sends an initialization message to establish session. The
message contains parameters to be negotiated.
4. When R1 receives the message from R2, it checks the param-
eters. If parameters pass the check, R1 will send an initializa-
tion message and a keepalive message to R2. Parameters to
be negotiated are included in the initialization message.
5. R2 checks the message from R1. If parameters pass the check,
R2 will send an initialization message to R1.
6. The session is established. During the procedure, if any error
messages are received, the session will be closed and the TCP
connection is interrupted.

Configuring MPLS

Enabling MPLS

To enable MPLS, perform the following steps.
mpls ip
interface vlan <vlan-number>
mpls ip
Note:
To disable MPLS LDP globally, use no mpls ip command in global
configuration mode.
To disable MPLS LDP on an interface, use no mpls ip command in
interface configuration mode.

Configuring LDP Router-ID

To configure LDP router-ID, use the following command.
Function
This enables LDP
This enters VLAN Layer 3
interface configuration mode
This enables MPLS LDP on
VLAN Layer 3 interface