Configuring A Static Route - Zte ZXR10 5900E Series Configuration Manual

ZXR10 5900E Series Configuration Guide (IPv4 Routing)

1.2 Configuring a Static Route

Next hop addresses must be specified for all routing items. When a packet is sent, the
system queries the matched route in the routing table according to the destination address.
If the next hop address is not specified, the link layer cannot find the corresponding address
on the link layer, and the packet cannot be forwarded.
Configuring Direct Static Route
To configure direct static route on ZXR10 5900E, use the following command.
Command
ZXR10(config)#
>{<next hop address>|<interface-name><next hop address>}[<
distance-metric>]
Descriptions of the parameters used by command are shown below.
Parameter
<vrf-name>
<prefix>
<net-mask>
<next hop address>
<interface-name>
<distance-metric>
Configuring Indirect Static Route
To configure indirect static on ZXR10 5900E, use the following command.
Command
ZXR10(config)#
ext hop address>[global]}[<distance-metric>][metric <metric>]
Descriptions of the parameters used by command are shown below.
SJ-20150114102049-003|2015-01-15 (R1.0)
ip route [vrf <vrf-name>]<prefix><net-mask
Description
It is used to configure static route of the designated Virtual
Route Forwarding Table (VRF).
The length of VRF name ranges from 1 to 32 characters.
Management port (mng) is a special VRF.
Network Internet Protocol (IP) prefix, in dotted decimal
notation
Network Mask, in dotted decimal notation
IP address of the next hop, in dotted decimal notation
Name of the used interface
Management distance, ranging from 1 to 255
ip route [vrf <vrf-name>]<prefix><net-mask>{<n
1-2
Function
This configures direct static route.
Function
This configures indirect static
route.
Judge whether the route is an
indirect static route according to IP
address of the next hop.
ZTE Proprietary and Confidential