Command
ZXR10(config-gei_1/x)#
le}
Command
ZXR10(config-gei_1/x)#
Command
interface {vlan <vlan-id>|<vlan-if>}
ZXR10(config)#
ingress filtering {enable|disab
When ingress filtering is enabled on a port, the port drops a re-
ceived frame if the VLAN to which the frame belongs does not
include the ingress. By default, VLAN ingress filtering is enable.
Setting Frame Filtering Type of a Port
To set frame filtering type of a port, use the following command.
acceptable frame types {all|tag}
This sets the frame type of the port which can receive all types
of frames including untagged and tagged frames. By default, all
frames are received.
Creating VLAN Layer 3 Interface
It is necessary to create this VLAN before creating VLAN layer 3
interface.
VLAN Configuration Example
The ports gei_1/1 and gei_1/2 on Switch A, and the ports gei_1/1
and gei_1/2 on switch B, belong to VLAN 10; the ports gei_1/4
and gei_1/5 on switch A, and the ports gei_1/4 and gei_1/5 on
switch B, belong to VLAN 20. The four ports are all access ports,
as shown in
Figure
ports gei_1/24 (two trunk ports) over a trunk link.
Confidential and Proprietary Information of ZTE CORPORATION
Function
This sets VLAN filtering on a
port.
Function
This sets frame filtering type of
a port.
Function
This creates VLAN layer 3
interface.
3. Switches A and B are connected through
Chapter 1 VLAN Configuration
9