Figure 1-1 Indirect Static Route Next Hop Configuration Example - Zte ZXR10 5900E Series Configuration Manual

Parameter
<vrf-name>
<prefix>
<net-mask>
<next hop address>
[global]
<interface-name>
[metric <metric>]
<distance-metric>
Configuration Example

Figure 1-1 Indirect Static Route Next Hop Configuration Example

As show in
can be configured on S1, the next hop is 20.20.20.2.
The configuration of static route on S1:
S1(config)#ip route 30.2.0.0 255.255.0.0 20.20.20.2
View route table on S1:
ZXR10(config)#show ip protocol routing
Protocol routes:
status codes: *valid, >best, i-internal, s-stale
Dest
*> 10.10.10.0/24
* 10.10.10.0/24
*> 10.10.10.1/32
*> 20.20.20.0/24
*> 30.2.0.0/16
SJ-20150114102049-003|2015-01-15 (R1.0)
Figure 1-1, S2 advertises 20.20.20.0/24 to S1. The static route to 30.2.0.0/16
NextHop RoutePrf
10.10.10.1 0
10.10.10.0 110
10.10.10.1 0
10.10.10.2 110
10.10.10.2
Chapter 1 Static Route Configuration
Description
It is used to configure static route of the designated VRF.
The length of VRF name ranges from 1 to 32 characters.
Network IP Prefix of destination address, in dotted decimal
notation
Network mask of destination address, in dotted decimal
notation
IP address of the next hop, in dotted decimal notation
Private network route can configure the next hop of public
network, only when the next hop of private network is
configured, it can be configured.
Name of the used interface
Metric value of route, range: 0-255, the default value is 0
Management distance, ranging from 1 to 255
RouteMetric Protocol
0 connected
1 ospf
0 connected
2 ospf
1 0 static
1-3
ZTE Proprietary and Confidential