Rep 6.9 Fuser Upper Cover Assembly/ Heat Rod - Xerox DocuPrint N2125 Service Manual

REP 6.9 Fuser Upper Cover Assembly/ Heat Rod

Parts List on PL 6.1
Removal
Switch off the power and disconnect the Power Cord.
1. Remove Fuser Assembly (REP 6.2).
2. Disconnect P/J274 from the left end of the Fuser Assembly
3. Remove the four screws securing the right and left end cover on the Fuser Assembly
ure 1).
4. Remove both covers while carefully disengaging the wiring harness on each end
1).
NOTE: The Heat Rod must be removed before the Upper Cover Assembly to avoid break-
age.
5. Invert the Fuser Assembly to access the Fuser Heat Rod
6. Remove the three screws securing the Fuser Heat Rod and Harness
NOTE: Avoid touching the glass rod with your fingers. Oil from your skin will contaminate
and shorten the life of the Heat Rod.
7. Carefully remove the Heat Rod by lifting the right end sliding it out to the right side of the
Heat Roll (Figure 3).
8. Return the Fuser Assembly to it's right side up position
9. Remove the four screws and the Fuser Upper Cover
Figure 1 Fuser Assembly
Repair-Adjustment
REP 6.9
WARNING
(Figure 1).
(Figure 2)
(Figure
(Figure 4).
(Figure 4).
(Fig-
(Figure
2).
Replacement
1. Reinstall the components in the reverse order.
02/2000
4-50
Figure 2 Fuser Heat Rod
Figure 3 Heat Rod
Figure 4 Fuser Upper Cover
Initial Issue
DocuPrint N2125