E6-1 Jam
E6-1 is the specified time that the paper has to turn the OCT Sensor Assembly Low after it has
turned the Sensor Exit High. If the Sensor Assembly Exit does not go Low after the specified
time, the Print Engine Controller PWB detects that an OCT jam has occurred.
E6-2 Jam
One of the conditions of the E6-2 jam is the same as the condition of the E6-1 jam. Another is
the signal of the OCT Exit Sensor Assembly turns Low during the warming-up.
General Procedures / Information
GP 3.12 , GP 3.13
GP 3.13 Option Feeder Assembly
The Paper Path for the Option Feeder Assembly
Paper that is fed from the Optional Feeder Assembly follows the path shown in Figure 1.
Figure 1 The Option Feeder Paper Path
02/2000
6-44
Initial Issue
DocuPrint N2125