Rep 3.13 Tray 1 Size Pwb; Rep 3.14 Size Harness Assembly - Xerox DocuPrint N2125 Service Manual

REP 3.13 Tray 1 Size PWB

Parts List on PL 9.1
Removal
These components are susceptible to electrostatic discharge. Observe all ESD procedures to
avoid damage.
Switch off the power and disconnect the Power Cord.
1. Remove Tray 1.
2. Remove all optional feeders.
3. Remove the Left Interface Cover (REP
4. Remove Left Cover (REP 1.2).
5. Remove the Front Cover Assembly
6. Remove the Left Front Cover Assembly
7. Remove Top Cover Assembly (REP
8. Remove the Left Plate Assembly (REP
9. Remove the Plate Handle (REP 1.12).
10. Remove the Size Sensor Housing (REP
11. Remove the Size Sensor Actuators
12. Remove the two screws that secure the Tray 1 Size PWB to the Size Sensor Housing
ure 1)
13. Lift the PWB and disconnect P/J51 and P/J331.
Figure 1 Tray 1 Size PWB
Replacement
1. Reinstall the components in the reverse order.
Repair-Adjustment
REP 3.13, REP 3.14
CAUTION
WARNING
1.1).
(REP 1.6).
(REP 1.7).
1.4).
1.11).
3.11).
(REP 3.12)

REP 3.14 Size Harness Assembly

Parts List on PL 9.1
Removal
Switch off the power and disconnect the Power Cord.
1. Remove Tray 1.
2. Remove the Left Interface Cover
3. Remove Left Cover (REP
4. Remove the Front Cover Assembly
5. Remove the Left Front Cover Assembly
6. Remove Top Cover Assembly
7. Remove the Left Plate Assembly
8. Remove the Plate Handle
9. Remove the Size Sensor Housing
10. Disconnect P/J51 from the Tray 1 Size PWB
11. Remove the two screws that secure the Size Harness Assembly to the Sensor
12. Remove the Size Harness Assembly
(Fig-
Figure 1 Size M Harness Assembly
Replacement
1. Reinstall the components in the reverse order.
02/2000
4-28
WARNING
(REP 1.1).
1.2).
(REP 1.6).
(REP 1.7).
(REP 1.4).
(REP 1.11).
(REP 1.12).
(REP 3.11).
(Figure 1).
(Figure 1).
(Figure 1).
Initial Issue
DocuPrint N2125