Rep 7.1 Btr Assembly; Rep 7.2 Print Cartridge Top Guide Assembly - Xerox DocuPrint N2125 Service Manual

REP 7.1 BTR Assembly

Parts List on PL 6.1
Removal
Switch off the power and disconnect the Power Cord.
Do not touch the surface of the BTR with your hands. Oil from your hands can cause
image quality problems.
After removing the BRT Roll, store the Roll on clean paper and cover with another sheet
of paper.
1. Open the Front Cover Assembly and remove the Print Cartridge.
2. Push down to release the left and right latches of the BTR Assembly
3. Holding the ends of the BTR Assembly, remove the assembly
Figure 1 BTR Assembly
Replacement
1. Reinstall the components in the reverse order.
Initial Issue
DocuPrint N2125
WARNING
(Figure
(Figure 1).

REP 7.2 Print Cartridge Top Guide Assembly

Parts List on PL 8.1
Removal
Switch off the power and disconnect the Power Cord.
1. Remove Tray 1.
2. Remove the Left Interface Cover Assembly
3. Remove the Option Cover
4. Remove the Front Cover Assembly
5. Remove the Left Front Cover
1).
6. Remove the Top Cover Assembly
7. Remove the Left Plate Assembly
8. Open the Rear Cover.
9. Disconnect P/J 25 from the Print Engine Controller PWB
10. Remove the two screws that secure the Print Cartridge Top Guide Assembly to the printer
(Figure 1).
11. Remove the Print Cartridge Top Guide Assembly together with the Print Cartridge Sensor
Assembly from the printer
Replacement
1. Reinstall the components in the reverse order.
02/2000
4-51
WARNING
(REP 1.2)
(REP 1.3).
(REP 1.6).
(REP 1.7).
(REP 1.4).
(REP 1.11).
(REP
(Figure 1).
Figure 1 EP Cartridge Top Guide Assembly
9.3).
Repair-Adjustment
REP 7.1, REP 7.2