Rrp 6.9 Fuser Upper Cover Assembly/ Heat Rod - Xerox 4400DT - Phaser B/W Laser Printer Service Manual

RRP 6.9 Fuser Upper Cover Assembly/ Heat Rod

See the Parts List on
Warning: Switch off the power and disconnect the Power Cord.
1. Remove Fuser Assembly
2. Disconnect P/J274 from the left end of the Fuser Assembly.
3. Remove the four screws securing the right and left end cover on the Fuser
Assembly.
4. Remove both covers while carefully disengaging the wiring harness on each end.
Note: The Heat Rod must be removed before the Upper Cover
Assembly to avoid breakage.
5. Invert the Fuser Assembly to access the Fuser Heat Rod
6. Remove the three screws securing the Fuser Heat Rod and Harness.
Note: Avoid touching the glass rod with your fingers. Oil from your
skin will contaminate and shorten the life of the Heat Rod.
7. Carefully remove the Heat Rod by lifting the right end sliding it out to the right
side of the Heat Roller.
8. Return the Fuser Assembly to its right side up position.
9. Remove the four screws and the Fuser Upper Cover.
Fuser Assembly
Fuser Heat Rod
Phaser 4400 Laser Printer Service Manual
page 7-18.
(RRP 6.2 Fuser Assembly on page 6-66).
6-77