Deletions (Line, Band, Spots); Fusing - Xerox DocuPrint N2125 Service Manual

Deletions (Line, Band, Spots)

Procedure
Inspect Test Prints for the presence of deletions (missing image). There should be no deletions
with a diameter larger than 0.5 mm visible on test prints
the test prints.
Y N
Go to Fusing.
There are vertical (in direction of paper movement) Line/Band deletions present.
Y N
There are Horizontal (in direction of scanning) Line/Band Deletions present.
Y N
There are Spot Deletions present.
Y N
Go to Fusing.
Go to IQ RAP 6 Spot Deletions.
Go to IQ RAP 4 Horizontal Deletions.
Go to IQ RAP 5 Vertical Deletions.
Figure 1 Line, Band, or Spot Deletions.
Initial Issue
DocuPrint N2125
(Figure 1). There are deletions on
02/2000
3-7

Fusing

Procedure
NOTE: The operating environment of the printer is from 41° F (5° Celsius) at 15% relative
humidity to 95° F (35° Celsius) at 85% relative humidity. The fusing performance of the printer
will vary according to the environment.
• A cold environment will affect the warm-up time.
• The weight (lb. / gsm) of the paper or transparency will affect the fusing of prints.
• High humidity will have an adverse affect on the fusing of prints.
Check the fusing quality of the image of a System Controller Test Print
image three times with a soft cloth or tissue. The image should not lift off of the surface of the
print. The fusing quality of the image meets the specification.
Y N
Go to IQ RAP 17 Unfused Image.
Go to Resolution.
Figure 1 Fusing Quality.
(Figure 1). Rub the
Image Quality Repair Analysis Procedures
Deletions , Fusing