Offset Catch Tray - Xerox DocuPrint N2125 Service Manual

Offset Catch Tray

Wiring Diagrams and Signal Information
This section of the manual contains a Block Diagram for the N2125 OCT. The Block Diagram
shows the interconnections of the major subsystems within the printer. The remainder of this
section divides the Block Diagram into individual block diagrams to better illustrate the electri-
cal relationships between components and assemblies within the Offset Catch Tray. Each wire
in the block diagram is tagged with a signal name, and each wire is terminated at both ends
with a pin number.
Block Diagram
1. OCT Block Diagram
2. Print Engine Controller PWB <=> OCT PWB (Figure 3) (Table 2)
3. OCT PWB <=> Stack Full Sensor, OCT Home Sensor, OCT Exit Sensor Assembly and
Direction Solenoid (Figure 4) (Table 3)
4. OCT PWB <=> Drive Motor Assembly and Offset Motor Assembly (Figure 5) (Table 4)
Location of P/J Connectors
Use the P/J table (Table 1) and the P/J map
the Feeder and Cassette.
1. Locate the P/J connector number in the first column of the table.
2. Locate the corresponding coordinates in the second column, such as I7 or J7.
3. Go to the map.
4. Cross-reference the letter and number of the P/J coordinates with the letters and numbers
on the map.
5. The P/J connector is located within the area where the coordinates cross.
Wiring Data
Offset Catch Tray
(Figure 1) to locate a specific P/J connector within
02/2000
7-28
Initial Issue
DocuPrint N2125