Rep 3.4 Stack Height Sensor; Rep 3.5 Low Paper Sensor - Xerox DocuPrint N2125 Service Manual

REP 3.4 Stack Height Sensor

Parts List on PL 3.1
Removal
Switch off the power and disconnect the Power Cord.
1. Remove Tray 1.
2. Remove the Left Interface Cover Assembly
3. Remove the Left Cover (REP 1.2).
4. Remove the Front Cover Assembly
5. Remove the Left Front Cover (REP
6. Remove the Left Plate Assembly (REP
7. Remove the Plate Handle (REP 1.12).
8. Open Rear Door.
9. Remove the Top Cover Assembly (REP
10. Remove the Right Cover (REP 1.5).
11. Remove the LVPS PWB (REP 9.5).
12. Remove the Paper Feeder (REP 3.1)
13. Remove the No Paper Actuator (REP
14. Disconnect P/J662 from the Stack Height Sensor
15. Release the five hooks, and remove the Sensor
Figure 1 Stack Height Sensor
Replacement
1. Reinstall the components in the reverse order.
Initial Issue
DocuPrint N2125
WARNING
(REP 1.1).
(REP 1.6).
1.7).
1.11).
1.4).
3.3)
(Figure 1).
(Figure 1).

REP 3.5 Low Paper Sensor

Parts List on PL 3.1
Removal
Switch off the power and disconnect the Power Cord.
1. Remove Tray 1.
2. Remove the Left Interface Cover Assembly
3. Remove the Left Cover (REP
4. Remove the Front Cover Assembly
5. Remove the Left Front Cover
6. Remove the Left Plate Assembly
7. Remove the Plate Handle (REP
8. Open Rear Door.
9. Remove the Top Cover Assembly
10. Remove the Right Cover (REP
11. Remove the LVPS PWB (REP
12. Remove the Paper Feeder (REP
13. Disconnect P/J661 from the Low Paper Sensor
14. Release the five hooks, and remove the Low Paper Sensor
Figure 1 Low Paper Sensor
Replacement
1. Reinstall the components in the reverse order.
02/2000
4-21
WARNING
(REP 1.1).
1.2).
(REP 1.6).
(REP 1.7).
(REP 1.11).
1.12).
(REP 1.4).
1.5).
9.5).
3.1)
(Figure 1).
(Figure 1).
Repair-Adjustment
REP 3.4, REP 3.5