Xerox DocuPrint N2125 Service Manual page 25

General Info Control Panel Message
Exit Jam 2 Exit Jam -
Open Rear Cover
Close Front Cvr
Close Rear Cvr
Jam in the OCT Offset Jam -
Open Rear Cover
OCT Jam Offset Jam -
Open Rear Cover
Paper Jam -
Open Front Cover
Paper Jam -
Open Rear Cover
Duplex Jam 3 Paper Jam -
Open Rear Cover
Duplex Jam 4 Paper Jam -
Open Rear Cover
Duplex Unit Fail or
Removed
Offset Bin Fail
Power Off/On
Envelope Feeder Fail or
Removed
Tray 2/3 Failure
Power Off/On
Initial Issue
DocuPrint N2125
Table 1 Error Code Table
Fault History Entry Diagnostic Message
E4-3 E4-3: Exit Jam
E5: FRNT/Rear Cover
E-5: Face Up Open
E6-1 E6-1: OCT Jam
E6-2 E6-2: OCT Jam
E7-0 E7-0: Duplex Jam
E7-1 E7-1: Duplex Jam
E7-2 E7-2: Duplex Jam
E7-3 E7-3: Duplex Jam
E9-1 E9-1: Duplex Fail
E9-2 E9-2: OCT Fail
E9-E E9: EBF Unit Fail
E11 E11: Tray 2/3 Fail
02/2000
2-7
Error Description Action
Custom Paper late off Exit Sensor Open Rear Cover
within a specified time from Registra- Clear Paper Path
tion Sensor. Change Paper Setting in Cus-
tom Mode to correct size.
Go to
1. Front cover interlock is open. Close Front Cover
2. Rear cover interlock is open. Close Rear Cover
Go to
Face Up Tray is open. Close Face Up Tray
Check Actuator
Check Sensor
Go to
1. Paper late to OCT Sensor. Open OCT Rear Door
Clear Paper Path
Open Printer Rear Cover
Clear Paper Path
Go to
Paper late off OCT Sensor. Open OCT Rear Door
OCT Sensor on at Power On Clear Paper Path
Go to
Paper arrives at Registration Sensor Open Front Cover
early from Duplex Sensor. Clear Paper Path
Go to
Paper late to Duplex Sensor Open the Rear Cover
Remove Duplex Unit Clear
Paper Path
Go to
1. Paper late off Duplex Sensor. Open Rear Cover
2. Duplex Sensor on at power up. Remove Duplex Unit
Clear Paper Path
Go to
Paper late to Registration Sensor Open Rear Cover
from Duplex Sensor. Remove Duplex Unit
Clear Paper Path
Go to
Duplex module removed while power Reinstall Duplex Module
is on. Go to
OCT removed while power is on. Switch Power Off
Remove and Reinstall OCT
Switch Power On
Go to
Envelope Feeder module removed Reinstall Envelope Feeder
while power on. Go to
Trays 2/3 disconnected after power Reinstall Trays 2/3
on. Go to
Status Indicator Repair Analysis Procedures
RAP 11.
RAP 12.
RAP 51.
RAP 57
RAP 57
RAP 56.
RAP 56.
RAP 56.
RAP 56.
RAP 55.
RAP 58.
RAP 62.
RAP 54.
Error Code Tables