GP 2.3 Keys Pad & LED Layout
Figure 1 illustrates the layout of the Control Panel
Figure 1 Keys Pad and LED Layout
General Procedures / Information
GP 2.3 , GP 2.4
GP 2.4 IOT Diagnostics
The IOT diagnostics provide the ability to:
•
Print IOT test page.
•
Read or Set IOT NVM configuration values. Access to NVM is password protected.
•
Monitor and verify operation of all input sensors for IOT and options.
•
Monitor and verify operation of all Output devices for IOT and options (motors, clutches,
etc.)
Table 1 summarizes the operation of the Control Panel Keys for entering IOT diagnostics.
Table 1 Entering IOT Diagnostics
Key Combination
-
Item Up + Item Down
Enter
The IOT diagnostic menu has the following selections:
•
Test Print
•
NVM Config
•
Component Test
Table 2 summarizes the operation of the Control Panel keys in IOT diagnostic main menu.
Table 2 IOT Diagnostic Mode Key Table
Key Combination
-
Menu Up / Menu Down
On-line
(Press and hold for 1 second)
02/2000
6-16
Key Number Action
2 + 6
While turning on power press and hold until
message "*IOT*" is displayed on the LCD (it
takes approximately 30 seconds).
During this time the following occurs:
•
Switch printer power on
•
Squares (light)
•
Boot Code Version
•
IOT displayed
4
After *IOT* is displayed the ENTER key must
be pressed within 5 sec. to enter Diagnostics.
If the ENTER key is not pressed within 5 sec.,
printer will continue its normal power up
sequence.
Key Number Action
1 or 5
Scroll through the IOT diagnostic menu: Print
Menu, NVM Menu, Component Menu.
0
Stops routing in process and clears error mes-
sages from Control Panel.
Initial Issue
DocuPrint N2125