Rep 2.4 Motor Assembly - Xerox DocuPrint N2125 Service Manual

REP 2.4 Motor Assembly

Parts List on PL 2.2
Removal
Switch off the power and disconnect the Power Cord.
1. Remove Tray 1.
2. Remove the two screws that secure the Rear L Holder to Tray 1
3. Remove the Motor Spring (Figure 1).
4. Remove the bearing (Figure 1).
NOTE: It may be necessary to use a scribe or small screwdriver to lift the locking tabs to
disconnect P/J672
5. Press the Socket Guide slightly and disconnect P/J672
6. Remove the three screws securing the Motor to the Motor Assembly
7. Remove the Motor (Figure 2).
Figure 1 Rear L Holder
Repair-Adjustment
REP 2.4
WARNING
(Figure 1).
(Figure 2).
(Figure 2).
Replacement
1. Reinstall the components in the reverse order.
02/2000
4-16
Figure 2 Motor Assembly
Initial Issue
DocuPrint N2125