Rep 12.8 Motor Assembly; Rep 12.9 Rear Roll Assembly - Xerox DocuPrint N2125 Service Manual

REP 12.8 Motor Assembly

Parts List on PL 13.2
Removal
Switch off the power and disconnect the Power Cord.
1. Remove the Duplex Assembly (REP
2. Remove the Duplex Cover (REP 12.3).
3. Remove the Drive Cover (REP 12.5).
4. Disconnect P/J38 from the Duplex PWB
5. Remove the harness from all cable clamps
6. Remove the two screws that secure the Motor Assembly
7. Remove the Motor Assembly (Figure
Figure 1 Motor Assembly
Replacement
1. Reinstall the components in the reverse order.
Initial Issue
DocuPrint N2125
WARNING
12.1).
(Figure 1).
(Figure 1).
(Figure 1).
1).

REP 12.9 Rear Roll Assembly

Parts List on PL 13.2
Removal
Switch off the power and disconnect the Power Cord.
1. Remove the Duplex Assembly
2. Remove the Turn Chute Assembly
3. Remove the Duplex Cover (REP
4. Remove the Drive Cover (REP
5. Remove the Motor Assembly
6. Release the locking tab and remove the Rear Belt Stopper
7. Remove the Duplex Gear (Figure
8. Remove Gears 17 and 18 (Figure
9. Release the locking tabs and remove both the left and right bearings
10. Move the Rear Roll Assembly forward, then to the left until the right end is free
11. Remove the Rear Roll Assembly
Figure 1 Locking Tab and Rear Belt Stopper
02/2000
4-97
WARNING
(REP 12.1).
(REP 12.2).
12.3).
12.5).
(REP 12.8).
(Figure 1).
1).
1).
(Figure
(Figure 2).
Repair-Adjustment
REP 12.8, REP 12.9
1).
(Figure 2).