REP 10.8 Motor Drive Assembly
Parts List on
PL 14.2
Removal
Switch off the power and disconnect the Power Cord.
1.
Remove the Offset Catch Tray
(REP
2.
Remove the Exit Tray Extension
(REP
3.
Remove the Exit Tray
(REP
10.3).
4.
Turn the Offset Catch Tray upside down.
5.
Remove the Lower Cover
(REP
10.5).
6.
Hold open the Rear Cover.
7.
Remove the Inner Exit Chute Assembly
8.
Remove the two screws that secure the motor to the Inner Exit Chute Assembly
1).
9.
Disconnect P/J210 from the Offset Catch Tray PWB and remove the motor
Figure 1 Motor Drive Assembly
Replacement
1.
Install the motor with both tabs touching the plastic standoffs.
2.
The ground wire on top and the earth plate at the bottom should be on the outside
1).
3.
Reinstall the components in the reverse order.
Initial Issue
DocuPrint N2125
WARNING
10.1).
10.2).
(REP
10.6).
(Figure
REP 10.9 Static Eliminator
Parts List on
PL 14.2
Removal
Switch off the power and disconnect the Power Cord.
1.
Remove the Offset Catch Tray
2.
Remove the Exit Tray Extension
3.
Remove the Exit Tray
(REP
4.
Turn the Offset Catch Tray upside down.
5.
Remove the Lower Cover
6.
Hold open the Rear Cover.
7.
Remove the Inner Exit Chute Assembly
(Figure
8.
Remove the three screws that secure the Static Eliminator to the Inner Exit Chute
1).
1).
9.
Remove the Static Eliminator
Replacement
1.
Reinstall the components in the reverse order.
(Figure
02/2000
4-71
WARNING
(REP
10.1).
(REP
10.2).
10.3).
(REP
10.5).
(REP
10.6).
(Figure
1).
Figure 1 Static Eliminator
REP 10.8, REP 10.9
(Figure
Repair-Adjustment