REP 10.2 Fuser Heat Roll
Parts List on
PL 10.2
Removal
Switch off the Main Power Switch. Disconnect the Power Cord. Allow the Fuser Assem-
bly to cool before the procedure is performed.
1.
(Figure 1): Access the Fuser Module.
1
Pull up on the handle and pull open the
Fuser Module Drawer
Figure 1 Accessing the Fuser Module
2.
Remove the Heat Rods
(REP
10.1).
8850/ 510DP
WARNING
Wear protective gloves when handling parts with silicone oil on them. Do not allow sili-
cone oil to contact your eyes. Silicone oil can cause severe eye irritation. Wash your
hands immediately after handling any component covered with silicone oil.
3.
(Figure 2): Remove the Web Oiler Assembly.
2
Slightly lift the Oil Assembly and move to
the right to clear the left side tabs
1
Remove the two right side screws
Figure 2 Removing the Web Oiler Assembly
03/2003
4-115
WARNING
Repairs and Adjustments
REP 10.2