Rep 6.7 Mid 1 & Mid 2 Roll Assemblies - Xerox DocuPrint N2125 Service Manual

REP 6.7 Mid 1 & Mid 2 Roll Assemblies
Parts List on PL 7.1
Removal
Switch off the power and disconnect the Power Cord.
1. Remove Tray 1.
2. Remove the Left Interface Cover Assembly
3. Remove the Left Cover (REP 1.2).
4. Remove the Front Cover Assembly
5. Remove the Left Front Cover (REP
6. Remove the Top Cover Assembly (REP
7. Remove the Rear Cover Assembly
8. Remove the Interlock Cover (REP 1.10).
9. Remove the Left Plate Assembly (REP
10. Remove the Exit Chute Assembly (REP
11. Lift the Static Eliminator Assembly and remove
12. Remove the Stack Full Actuator (REP
13. Release the locking tab and remove the Exit-17 Gear from the defective Roll Assembly
(Figure 1), (Figure 2), or (Figure 3).
14. Remove the Exit-32 Gear from the Exit Chute Assembly
15. With a small screwdriver carefully release the locking tab that secures the Exit Bearings to
the Exit Chute Assembly (Figure 1),
16. Remove the Roll Assembly together with the Exit Bearing from the Exit Chute Assembly
(Figure 1), (Figure 2), or (Figure 3).
17. Remove the left Exit Bearing from the Roll Assembly.
Initial Issue
DocuPrint N2125
WARNING
(REP 1.1).
(REP 1.6).
1.7).
1.4).
(REP 1.8).
1.11).
6.4).
(Figure 1) (See REP 6.8 - step 6).
6.8).
(Figure 1).
(Figure 2), or (Figure 3).
Figure 1 Exit 17 & Exit 32 Gears
02/2000
4-47
Repair-Adjustment
REP 6.7