Table 4-2 Terminal Emulator Settings - Silicon Graphics Origin200 Owner's Manual

Chapter 4: Operating an Origin200 System
92
Regardless of the type of terminal emulator you use, make sure it has the following
settings:
Table 4-2 Terminal Emulator Settings
Setting Value
Baud rate 9600
Data bits 8
Stop bits 1
Parity None
Local echo off
Terminal type DEC V100, VT102, Wyse 60, ANSI, or dumb
Flow Control None or XON/XOFF
To configure your terminal emulator, follow these general steps:
1. Power on your IBM compatible or Macintosh computer.
Do not turn on the Origin200 server yet.
2. When the system has booted, locate and start the terminal emulator.
3. Adjust the settings for your terminal emulator as indicated in Table 4-2.
Be sure the terminal emulator software is configured to use the serial port on
your computer to which you attached the serial cable.
Note which terminal type (such as VT100 or ANSI) you choose to emulate. You
will need this information when you log in to the Origin200 server.
Other settings, such as upload and download protocol, initialization strings,
and file transfer settings do not matter for this procedure. You can leave them
set to their defaults.