Installing 5.25-Inch Drives
If you are installing a non-Silicon Graphics 5.25-inch drive, see "Configuring a
Note:
5.25-Inch Peripheral" on page 161.
5.25-inch drives are installed in a removable carrier. Follow these step to remove the
carrier:
1.
Remove the door.
Pull the door open.
If your system is in a tower configuration, push down on the top, outer edge of
the door, as shown in Figure 2-8. The door pops off its hinges.
Figure 2-8
Removing the Front Door, Tower Configuration
Putting the Pieces Together
41