Figure 7-10 Replacing A Pci Option Blanking Plate And Screw - Silicon Graphics Origin200 Owner's Manual

Grasp the PCI option board at the front and rear of the board and pull it straight
up and out of the system, as shown in Figure 7-9.
Be careful not to kink or damage the flexible EMI gasket that surrounds the
inside of the rear chassis wall.
Place the PCI option board in an antistatic bag, preferably the bag in which the
board was originally packaged.
7. Replace the blanking plate.
Align the blanking plate and slide it in place, as shown in Figure 7-10.
Attach the screw that secures the blanking plate to the Origin200 chassis, as
shown in Figure 7-10.
Figure 7-10 Replacing a PCI Option Blanking Plate and Screw
Removing a PCI Option Board
155