Turning On The System; Figure 4-2 Turning On The Master Power Switch - Silicon Graphics Origin200 Owner's Manual

Chapter 4: Operating an Origin200 System
80

Turning On the System

Follow these steps to turn on the system:
1. At the rear of the system, turn the master power switch on, as shown in Figure 4-2.
Figure 4-2 Turning On the Master Power Switch
If you have a two-node system, turn on the master power switches for both
nodes. It does not matter which you turn on first.
When you turn on the master power switch, the status LED at the front of the
system flashes green momentarily.