Silicon Graphics Origin200 Owner's Manual page 122

Chapter 4: Operating an Origin200 System
96
3. Using a text editor, open the file /etc/uucp/Devices.
Locate the following line:
# Direct ttyd2 - 9600 direct
Remove the number sign (#) and subsequent space at the beginning of the line:
Direct ttyd2 - 9600 direct
This change allows you to use port 2 on the workstation to connect to the
Origin200 server. If you are using a different serial port, replace
line above with the name of the actual port you are using, for example,
.
ttyd4
Save the file and exit.
4. Edit the file /etc/uucp/Systems.
At the end of the file, add this line:
Direct Any Direct 9600 -
Save the file and exit.
5. Test the configuration on the workstation:
Enter this command at a shell prompt:
cu Direct
You should see this message:
Connected
This message means that cu has successfully opened the serial port. You are
ready to proceed to the next section, "Connecting the Serial Cable." Enter the
following command to exit from cu and return to the shell prompt:
~.
(This command is the tilde character, followed by a period.)
If you do not see the message
the previous steps. Repeat this procedure, starting from step 2. In particular,
make sure that you reference the same port in each of the files /etc/inittab and
/etc/uucp/Devices.
, you may have made an error in one of
Connected
in the
ttyd2
or
ttyd3