Chapter 2: Setting Up an Origin200 System
44
3. Install the 5.25-inch drive in the carrier. The carrier can hold one full-height drive or
two half-height drives.
Remove one or two of the blanking plates from the front of the carrier,
depending upon whether you are installing a half-height or a full-height drive.
Using a #2 Phillips screwdriver, remove the screws that hold the access plate to
the rear of the carrier, then remove the access plate. See Figure 2-11.
Removing a Blanking Plate and the Rear Access Plate From the Peripheral Carrier
Figure 2-11
Front
Rear